Table of Contents
Advertisement
S
ETUP
Electrical and Data Wiring Installation
Electrical and
Data Wiring
Installation
24
K250 I
NSTALLATION
Power & Data Lines from Wall:
NOTE: Both versions of the kiosk can also have the power and data routed
through the access hole at the base (shown below).
1
After the kiosk has been moved to the desired location, locate grommet or
mouse hole (see below).
2
6-foot NEMA (supplied) cable needs to be routed to the IEC port inside of the
kiosk (see below). Plug the other side of the NEMA cable into a local power
outlet.
3
There will be a power strip inside the kiosk that needs to be turned on.
4
An ethernet cable needs to be routed from the RJ45 port inside of the kiosk
enclosure and connected directly to the PC.
5
Manage cable as necessary.
6
Power on the PC inside of the kiosk by pressing the power button. (See
TURNING ON PC).
7
Ensure the display is turned on. If you are not seeing anything on the display,
remove the rear cover from behind the display and press the power button on
the back of the display (See TURNING ON DISPLAY).
G
UIDE
Advertisement
Table of Contents
