Table of Contents
Advertisement
K250 OWNER'S MANUAL
Extended & Slim
ELECTRICAL + DATA WIRING INSTALLATION
Power & Data Lines from Wall:
NOTE: Both versions of the kiosk can also have the power and data routed through the access hole
at the base (shown below).
1.
After the kiosk has been moved to the desired location, locate grommet or mouse hole (see below)
2.
6-foot NEMA (supplied) cable will need to be routed to the IEC port inside of the kiosk (see below).
Plug the other side of the NEMA cable into a local power outlet.
3.
There will be a power strip inside of the kiosk that will need to be turned on.
4.
An ethernet cable will need to be routed from the RJ45 port inside of the kiosk enclosure and
connected directly into the PC.
5.
Manage cable as necessary.
6.
Power on the PC inside of the kiosk by pressing the power button. (See TURNING ON PC on
page 13).
7.
Ensure the display is turned on. If you are not seeing anything on the display, remove the rear
cover from behind the display and press the power button on the back of the display (See
TURNING ON DISPLAY on page 14).
K250 Owner's Manual
This document, including all its content is solely intended for its designated recipient and is not to be forwarded to any other company, business entity or person, without written permission from VERIFONE, Inc |
All rights reserved | Any reproduction of this document, the artwork and or the industrial designs represented within it, in part or whole without permission is strictly prohibited
Page 18
Advertisement
Table of Contents
