Reprogramming A Single Homelink Button; Resetting Defaults - Hummer 2003 H2 Owner's Manual

Hide thumbs Also See for 2003 H2:

Table of Contents

Reprogramming a Single HomeLink Button

To program a device to HomeLink using a HomeLink

button previously trained, follow these steps:

1. Press and hold the desired HomeLink button.

Do not release the button.

2. The indicator light will begin to flash after

20 seconds. While still holding the HomeLink

button, proceed with Step 2 under "Programming

To reset HomeLink to default settings, hold down the

two outside buttons until the indicator light begins to

flash (approximately 20 seconds). Continue to hold both

buttons until the HomeLink indicator light turns off and

then release both buttons.

For questions or comments, contact HomeLink

3515, or on the internet at

www.homelink.com.

Table of Contents