Table of Contents
Advertisement
Front Reading Lamps
1.
2.
3.
4.
5.
6.
7 .
a.
Use
a
coin or srnall screwdriver to 11nscrew the
center of the overhead console lamp lens while
pressing in on the lamp assembly.
Remove the lamp assembly from the console.
Remove the bulb assembly from the lamp assembly.
Pull the bulb straight out of the base.
Put a new bulb into the bulb base.
Install the bulb assembly into t.he lamp assembly.
Place the lamp assembly into the console, turning
it
to latch
it
i n place.
Install
the
lens.
Vanity Mirror Lamps
4. Press the new bulb into place.
5 . Slide the
side tabs of the lens under the side
of the
vanity assembly frame.
6. Rotate the lens downward.
7. Snap the lens into the frame.
Windshield Wiper Blade Replacement
See "Normal Maintenance Replacement Parts" in the
Index for the proper type
of replacement blade.
NOTICE:
~~~~
Use care when removing or installing a blade
assembly. Accidental bumping can cause the arm
to fall back and strike the windshield.
1 . Insert
the
blade of a small screwdriver into the center
I
I
slot at the bottom
of the lens.
2. Gently pry the screwdriver down in order to lift out
the lens.
3. Pry out the bulb.
1.
To remove the old wiper blades, lift the wiper arm
until it locks into a vertical position.
6-38
Advertisement
Table of Contents
