Table of Contents
Advertisement
Operating the Transmitter
Press and hold the appropriate button
on
the universal
transmitter. The red light comes on while the signal is
being transmitted.
Note that the effective transmission range of the
universal transmitter may differ from the hand-held
transmitter and from one channel to another.
Erasing Channels
To erase all three programmed channels, hold down
the two outside buttons until the red light begins to
flash. Individual channels cannot be erased. but can be
reprogrammed using the procedure for programming the
transmitter explained earlier.
Training a Garage Opener with a "Rolling
Code" Feature
If you programmed the universal transmitter. but the
garage door will not open. and if your garage door opener
was manufactured after 1995, your garage door may have
a security feature that changes the "code" of your garage
door opener every time
it
is opened or closed.
To determine if your garage door opener has
this
"rolling code" feature. press the appropriate button
on
the
universal transmitter that was programmed. If the
red light tlashes rapidly for one to two seconds, then
turns solid, your garage door opener
has
this feature.
To program
a
garage door opener with the rolling code
feature, do the following:
1 .
-.
3
3.
4.
5.
6.
Program your hand-held transmitter to the universal
transmitter by following the steps provided under
"Programming the Transmitter" earlier in this section.
Remove the cover panel from the garage door opener
receiver. It is located near the garage door opener motor.
Locate the training button on the garage door opener
receiver. The exact location and color will vary
among brands.
Press the training button on the garage door opener
receiver for one to two seconds.
Return to your vehicle and press the programmed
button on the universal transmitter until the red light
flashes rapidly (about two seconds).
Release the button. then repress
it to
confirm
it
was
programmed to the garage door opener receiver.
You may now use either the universal transmitter or
the hand-held transmitter to open your garage door.
I f you still have difficulty in programming and
I
assistance. please call 1-800-355-35 15.
Accessories
Accessories for
the
universal transmitter are ava
.I
:quire
lable
from the manufitcturer of the
unit. If you
would like
additional information. please call 1-800-355-35 15.
2-66
Advertisement
Table of Contents
