GMC 1995 Jimmy Owner's Manual page 236

I
Tightening Wheel Nut
Tightening Sequence
Use the wrench to tighten the wheel nuts firmly in a criss-cross sequence as
shown. Remove the wheel blocks.
Storing the Jack and Spare Tire
Return the jack, wheel wrench and wheel blocks to the proper location in
your vehicle's rear area. Secure the items and replace the jack cover. Put the
flat tire where the spare tire was stored. If you
have the underbody carrier:
1. Put the tire on the ground at the rear of the vehicle, with the valve stem
2. Pull the retaining bar through the wheel.
pointed down and to the rear.
3. Put the chisel end of the wheel wrench, on an angle, through the hole in
the rear bumper and into the hoist shaft. Turn the wheel wrench
clockwise until the tire is raised against the underside of the vehicle.
You will hear two "clicks" when the tire is secure, but pull on the tire to
make sure.
5-34