Brother MFC260C Service Manual page 169

(9) Place the scanner cover upside down.
(10) To prevent the scanner cover support and damper from getting broken, remove them from the
scanner cover as follows.
Release the lock arm of the scanner cover damper from the scanner cover and pull out the
damper in the direction of arrows shown below. The scanner cover support also comes off.
CIS motor harness
Assembling Notes
• Route the CIS motor harness, document front and rear sensor harnesses*, ADF motor harness*
and grounding wire* as shown on the next page.
• If you replace the scanner cover, check the CIS type (Canon, Rohm, or Lite-On) printed on the
CIS bar code label on the new scanner cover and enter it to the EEPROM (Function code 59),
referring to Chapter 9, Section 9.1.4.13.
After that, acquire the white level data and set the CIS scanner area (Function code 55), referring
to Chapter 9, Section 9.1.4.11.
Scanner cover support
Scanner cover damper
Lock arm
(Rear)
Document front sensor harness*
Document rear sensor harness*
Grounding wire*
ADF motor harness*
6 - 1 0
CIS flat cable
*For models with ADF
Scanner cover
(placed upside down)
(6_09)
(*For models with ADF)
Confidential