Sharp MX-B427W User Manual page 63

Use printer menus
Menu item
Device Operations
Safe Mode
Off*
On
Device Operations
Clear Custom Status
Device Operations
Clear all remotely-installed messages
Device Operations
Automatically Display Error Screens
On*
Off
Scanner Configuration
Scanner Manual Registration
Print Quick Test
Scanner Configuration
Scanner Manual Registration
Front ADF Registration
Rear ADF Registration
Flatbed Registration
Scanner Configuration
Edge Erase
Flatbed Edge Erase
0–6 (3*)
ADF Edge Erase
0–6 (3*)
Scanner Configuration
Disable Scanner
Enabled*
Disabled
ADF Disabled
Scanner Configuration
Tiff Byte Order
CPU Endianness*
Little Endian
Big Endian
Note: An asterisk (*) next to a value indicates the factory default setting.
Description
Set the printer to operate in a special mode, in which it attempts
to continue offering as much functionality as possible, despite
known issues.
For example, when set to On, and the duplex motor is
nonfunctional, the printer performs one‑sided printing of the
documents even if the job is two‑sided printing.
Note: This setting cannot be used when the tray is not fully
inserted or the tray sensor is damaged.
Erase all custom messages.
Erase all remotely‑installed messages.
Show existing error messages on the display after the printer
remains inactive on the home screen for a length of time equal
to the Screen Timeout setting.
Print a Quick Test target page.
Note: Make sure that the margin spacing on the target page
is uniform all the way around the target. If it is not, then the
printer margins may need to be reset.
Manually register the flatbed and ADF after replacing the ADF,
scanner glass, or controller board.
Set the size, in millimeters, of the no‑print area around an ADF
or flatbed scan job.
Disable the scanner if it is not working properly.
Set the byte order of a TIFF‑formatted scan output.
63