Sharp MX-B427W User Manual page 187

Notices
This device uses an RJ-11C modular connector. Contact your point of purchase if a BT adapter is required. The
part number is 80D1873.
Some parameters required for compliance with Telecom's telepermit requirements are dependent on the
equipment associated with this device. The associated equipment shall be set to operate within the following
limits for compliance to Telecom's specifications:
•
There shall be no more than 10 call attempts to the same number within any 30 minute period for any single
manual call initiation, and
•
The equipment shall go on-hook for a period of not less than 30 seconds between the end of one attempt
and the beginning of the next call attempt.
•
The equipment shall be set to ensure that automatic calls to different numbers are spaced such that there
is not less than 5 seconds between the end of one call attempt and the beginning of another.
Japanese telecom notice
The installed optional modem is in compliance with Japanese Telecommunication Law and has been Certified
by JATE, with the following Certification Number:
A18-0046001
Using this product in Switzerland
This product requires a Swiss billing tone filter to be installed on any line which receives metering pulses in
Switzerland.
Utilisation de ce produit en Suisse
Cet appareil nécessite l'utilisation d'un filtre de tonalité de facturation suisse devant être installé sur toute ligne
recevant des impulsions de comptage en Suisse.
Verwendung dieses Produkts in der Schweiz
Für dieses Produkt muss ein schweizerischer Billing Tone Filter zur Zählzeichenübertragung für jede Leitung
installiert werden, über die in der Schweiz Zeitsteuertakte übertragen werden.
Lexmark International, Inc.
LEX-M14-002
A18-0046001
187