Table of Contents
Advertisement
[Setup via recorder's main monitor]
Set the black and white switchover of the camera [Day & Night (IR/electrical)]
Select the day and night setting for each camera and transmit the information to the cameras to change the
camera settings.
Clicking the [Setup >] button for "Day & Night (IR/electrical)" on the [Camera setup] tab will display the setup
window.
[Day & Night (IR/electrical)]
Select a method of how to switch between B/W
image and color image from the following.
Off: Color images will always be displayed.
On: The B/W image will be selected.
Auto1 (Normal)/Auto: Depending on the image
brightness (illuminance), the system automati-
cally switches from/ to the color image to/from
B/W image.
It switches to the color mode when the light
source is bright and to the monochrome mode
when the light source is not bright.
Auto2 (IR Light): Use it at night time or when using
near-IR light source.
Auto3 (Super Chroma Compensation (SCC)): Use
it if you want to keep the color image even if
the light source is not bright. Super Chroma
Compensation (SCC) function keeps the color
image under the lower illuminance than "Auto1
(Normal)".
Note:
• "On", "Auto2" and "Auto3" can be selected for
cameras having "Day & Night (electrical)" only, but
they are not operable.
■ Camera Selection
Select the camera to which the setting of the "Day &
Night (IR/electrical)" is to be sent.
Mark the checkbox of the camera to which the setup
information is to be transmitted.
[Transmission] button
Transmit the setting of the "Day & Night (IR/electrical)"
to the camera.
Once transmission is completed and the setting has
been applied to the camera, "OK" will be displayed in
the "Results" field.
If the display reads "Authentication error", etc., the
camera connection or the setting may have failed.
[Back] button
Click the button after completing the settings.
The screen returns to the [Camera setup] tab.
31
Advertisement
Table of Contents
