Chevrolet 2003 Monte Carlo Owner's Manual page 309

B
\
I
C
Jack placement for a rear tire
The diagram shows you where to place your jack to
change a rear tire. Use the notch
(B)
as a guide when
positioning the jack lift head (A) near the front edge
of the rear wheel opening (C).
For jacking at the vehicle's rear location, put the jack lift
head about 4 inches (10 cm) from the front edge of
the rear wheel opening in the cutout of the rocker panel
molding.
2. Raise the vehicle by turning the jack handle
clockwise. Raise the vehicle far enough off the
ground for the compact spare tire to fit underneath
the wheel well of the vehicle. Remove all wheel
nuts and take off the flat tire.
Put the compact spare tire near you.
5-74