Chevrolet 2003 Monte Carlo Owner's Manual page 180

4
SEEK
b
: Press the right or the left arrow to seek
to the next or to the previous station and stay there.
The radio will seek only to stations that are in the
selected band and only to those with a strong signal.
4
PSCAN (Preset
Scan)
b
: Press and hold one of
the arrows for more than two seconds. The radio will
produce one beep. The radio will scan through each of
the preset stations stored on the pushbuttons, play
for a few seconds, then go on to the next preset station.
SCAN will be displayed. Press one of the arrows
again or one of the pushbuttons to stop scanning
presets.
The radio will scan only to the preset stations that are in
the selected band and only to those with a strong
signal.
Setting Preset Stations
The six numbered pushbuttons let you return to your
favorite stations. You can set up to 30 stations (six AM,
six FMI and six FM2, six XM1 and six
XM2 (USA
only, if your radio is equipped with the XM Satellite
Radio Service) or DAB1 and DAB2 (Canada only, if your
radio is equipped with DAB), by performing the
following steps:
1. Turn ?he radio
OR.
2. Press BAND to select AM, FM1 or FM2, or XM1,
XM2, or DAB1, DAB2.
3.
4.
5.
6.
Tune in the desired station.
Press AUTO TONE to choose the bass and treble
equalization that best suits the type of station you
are listening to.
Press and hold one of the six numbered
pushbuttons. The radio wiii produce one beep.
Whenever you press that numbered pushbutton, the
station you set will return and the bass and treble
equalization that you selected will also be
automatically selected for that pushbutton.
Repeat the steps for each pushbutton.
Setting the Tone (Bassnreble)
AUDIO: Push and release the AUDIO knob until BASS
or TREB appears on the display. Turn the knob to
increase or to decrease. The display will show the bass
or the treble level. If a station is weak or noisy, you
may want to decrease the treble.
To adjust bass and treble to the middle position, push
ana noid ine A u u t u knob. The radio wiii
~ I U C L J C ~
one beep and adjust the display level to the middle
position.
To adjust all tone and speaker controls to the middle
position, push and hold the AUDIO knob when no tone
or speaker control is displayed. ?he rads will produce
one beep and display ALL with the level display in
the middle position.
.-.
3-65