Taillamps, Turn Signal, Stoplamps And Sidemarker Lamps - Chevrolet 2003 Impala Owner's Manual

9.
10.
Install the new bulb by inserting the smallest tab on
the bulb base into the matching notch in the
retaining ring. Turn the bulb a quarter-turn clockwise
until it stops.
Reverse Steps 1 through 5 to reinstall the headlamp
assembly. Then, check the lamps.
Taillamps, Turn Signal, Stoplamps
and Sidemarker Lamps
A. Rear Sidemarker Lamp
B. Taillamps/Turn Signal and Stoplamp
1. Open the trunk. Remove the convenience net, if
your vehicle has one. Unhook the net from the
upper wing nut.
wing nuts.
2. Remove the two upper (convenience net)
3. Pull the carpet away from the rear of the vehicle.
4. Unscrew the
two remaining
wing nuts.
a.
r u I I L I I ~ ~ ~ ~ ~ I I U I Y I I U I I I L I I ~
uuuy
~ a r e l u l l y .
r
n.
. I I IL
- - - -
-.--I-
I .
. x . . -
-
I-
-
_ I ~
~
- -
.
_ r ~
I I ~
6. To remove a socket, press the tab, turn the socket
counterclockwise and pull it out.
7. Pull the old bulb out. Do not twist it.
8. Push the new bulb into the socket.
9. Reinstall the socket in the assembly. Tighten the
socket by turning it clockwise.
5-57