Chevrolet 2003 Impala Owner's Manual page 274

Using the Radio
Using the Accelerator Pedal
1. Turn the ignition to ON, with the engine off.
2. Fully press and release the accelerator pedal three
times within five seconds. If the CHANGE ENGINE
OIL message flashes, the system is reset.
However, if it stays on, it did not reset. You'll need
to repeat the reset procedure.
What to Do with Used Oil
Used engine oil contains certain elements that may be
unhealthy for your skin and could even cause cancer.
Don't let used oil stay on your skin for very long. Clean
your skin and nails with soap and water, or a good
hand cleaner. Wash or properly dispose of clothing or
rags containing used engine oil. See the manufacturer's
warnings about the use and disposal of oil products.
Used oil can be a threat to the environment. If you
change your own oil, be sure to drain all the oil from the
filter before disposal. Never dispose of oil by putting it
in the trash, pouring it on the ground, into sewers, or into
sirearns or bodies o i
waier. insieaa, recycie ii by
taking it to a place that collects used oil. If you have a
problem properly disposing of your used oil, ask
your dealer, a service station or a local recycling center
for help.
1.
2.
3.
4.
5.
6.
7.
8.
Turn the ignition to ACC or ON, with the radio off.
Press and hold the TUNE DlSP button on the radio
for at least five seconds until SETTINGS is
displayed.
Press the SEEK PSCAN up or down arrow to scroll
through the main menu.
Scroll until OIL LIFE appears on the display.
Press the 1 PREV or 2 NEXT buttons to enter the
submenu. RESET will be displayed.
Press the TUNE DISP button to reset. A chime will
be heard to verify the new setting and DONE will
be displayed for one second.
Once the indicator has been reset, scroll until EXIT
appears on the display.
Press the TUNE DlSP button to exit programming.
A chime will be heard to verify the exit.
5-2 1