Using Memory Function; Viewing The Readings Stored In Memory - Omron 10 Series Instruction Manual

5. Using Memory Function

Your monitor automatically stores up to 100 readings per user.
Note
•This monitor can be used by multiple users. Refer to sub-section 2.8
to switch user. Make sure which user ID stores your own readings.
5.1

Viewing the Readings Stored in Memory

1. Select your user ID.
2. Press the
If the past reading was
taken in TruRead mode,
the "
and the reading shown
on the left is the average
of 3 measurements.
After a memory number appears, the latest reading will
appear with a past reading. A past reading will appear in the
comparison display on the left.
Note
• If the reading is high (refer to sub-
section 1.3), the "
appears.
• If there are no readings stored in
the memory, the screen to the right
is displayed.
• If the memory is full, new readings
will replace the old readings, starting with the oldest reading.
32
button.
Memory number
" symbol appears
1 sec.
Past reading
If the latest reading was
taken in TruRead mode,
the "
appears and the reading
shown on the right is the
average of 3 measurements.
" symbol
Alternating
date/time
display
Latest reading
" symbol