Getting Started with your Omron 10 Series + ™ BP791IT Blood Pressure
Welcome!
This guide will show you how to set up your Omron 10 Series + Blood Pressure Monitor (Model BP791IT)
to work with Microsoft HealthVault.
With this guide, you will:
1. Set up your blood pressure monitor and take a test reading.
2. Get ready to use your blood pressure monitor with HealthVault.
3. Connect your blood pressure monitor to your computer and upload your test reading to
HealthVault.
IMPORTANT: If you have not already created your HealthVault account and installed HealthVault
Connection Center, please go to http://healthvault.com/connectioncenter and follow the instructions
Let's get started!
Step 1: Set up your blood pressure monitor and take a test reading
IMPORTANT: Do not download or install the Omron Health Management Software if you are planning
to use HealthVault.
IMPORTANT: The blood pressure monitor should not be connected to your computer
while you are taking a measurement. Before taking a measurement, please disconnect
the USB cable.
Open your blood pressure monitor packaging. Remember, you will NOT be downloading or
installing the Omron Health Management Software.
Remove the device, cuff, cords, and batteries from their plastic packaging.
Install the four AA batteries included or connect the AC adapter.
Set the date and time on your device as described below:
o If the device is on, turn it off by pressing the start/stop button
o Press and hold the 'Set' Button until the screen displays a flashing 'off'
o Press the set button again
o Set the year
Monitor and Microsoft® HealthVault™
If the year is not correct:
•
press the up button
•
press the down button
Once the year is correct, press the set button again
to increase the year
to decrease the year
1
.