Turn And Lane Change Signals - Chevrolet 2001 Prizm Owner's Manual

Turn and Lane Change Signals

The turn signal has an upward (for right) and a
downward (for left) position. These positions allow
you to signal a turn or a lane change.
To signal a turn, move the lever all the way up
or down. When the turn is finished, the lever
will return automatically.
To signal a lane change, just raise or lower the lever
until the arrow starts to flash. Hold it there until you
complete your lane change. The lever will return by
itself when you release it.
If you signal a turn or a lane change and notice the
arrow flashing rapidly, a signal bulb may be burned out
and other drivers won't see your turn signal.
2-30
An arrow on the instrument
panel cluster will flash in
the direction of the turn or
lane change.
If a bulb is burned out, have it replaced to help avoid an
accident. If the arrows don't go on at all when you
signal a turn, check for burned
the fuse (see "Fuses and Circuit Breakers" in the Index).
Headlamp High/Low Beam Changer
It will go off when you switch to the low beams.
To switch back to low beams, pull the lever toward you.
Flash-to-Pass
-
With the lever in the low
lever toward you to momentarily switch to high beams
(to signal that you are going to pass). If you have
the headlamps on when you release the lever, they will
return to the low beams.
-
out bulbs and then check
First, you must have the
headlamps on. For high
beams, push the turn signal
lever away from you. When
the high beams are on, this
light on the instrument panel
cluster also will be on.
beam position, pull the