Copying A Configuration File From The Device To The Ftp Server - Cisco Catalyst 9500 Manual

Copying a Configuration File from the Device to the FTP Server

Copying a Configuration File from the Device to the FTP Server
To copy a startup configuration file or a running configuration file from the device to an FTP server, complete
the following tasks:
SUMMARY STEPS
1. enable
2. configure terminal
3. ip ftp username username
4. ip ftp password password
5. end
6. Do one of the following:
DETAILED STEPS
Command or Action
Step 1 enable
Example:
Device> enable
Step 2 configure terminal
Example:
Device# configure terminal
Step 3 ip ftp username username
Example:
Device(config)# ip ftp username NetAdmin1
Step 4 ip ftp password password
Example:
Device(config)# ip ftp password adminpassword
Step 5 end
Example:
Device(config)# end
System Management Configuration Guide, Cisco IOS XE Fuji 16.8.x (Catalyst 9500 Switches)
192
• copy system:running-config ftp: [[[//[username [:password ]@]location]/directory ]/filename ]
or
• copy nvram:startup-config ftp: [[[//[username [:password ]@]location]/directory ]/filename ]
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Enters global configuration mode on the device.
(Optional) Specifies the default remote username.
(Optional) Specifies the default password.
(Optional) Exits global configuration mode. This step is
required only if you override the default remote username
or password (see Steps 2 and 3).
Managing Configuration Files