Cisco Catalyst 9500 Manual page 279

Conditional Debug and Radioactive Tracing
Conditions Direction
----------------------------------------------------------------------------------------------|---------
MAC Address 0024.D7C7.0054 N/A
Feature Condition Type Value
-----------------------|-----------------------|--------------------------------
Packet Infra debugs:
Ip Address Port
------------------------------------------------------|----------
Device#
The following is a sample of the debug platform condition stop command.
Device# debug platform condition stop
Conditional Debug Global State: Stop
Additional References for Conditional Debugging and
Radioactive Tracing
Related Documents
Related Topic
For complete syntax and usage information for
the commands used in this chapter.
Feature History for Conditional Debugging and Radioactive
Tracing
This table provides release and related information for features explained in this module.
These features are available on all releases subsequent to the one they were introduced in, unless noted
otherwise.
Release
Cisco IOS XE Everest 16.5.1a
Cisco IOS XE Fuji 16.8.1a
Additional References for Conditional Debugging and Radioactive Tracing
Feature
Conditional Debugging
and Radioactive Tracing
Conditional Debugging
and Radioactive Tracing
System Management Configuration Guide, Cisco IOS XE Fuji 16.8.x (Catalyst 9500 Switches)
Document Title
Command Reference (Catalyst 9500 Series Switches)
Feature Information
The Conditional Debugging feature allows you to
selectively enable debugging and logging for
specific features based on the set of conditions you
define.
Support for this feature was introduced only on the
C9500-12Q, C9500-16X, C9500-24Q, C9500-40X
models of the Cisco Catalyst 9500 Series Switches.
Support for this feature was introduced only on the
C9500-32C, C9500-32QC, C9500-48Y4C, and
C9500-24Y4C models of the Cisco Catalyst 9500
Series Switches.
265