Cisco Catalyst 9500 Manual page 243

Configuration Replace and Configuration Rollback
Note Before using the archive config command, you must configure the path command to specify the location
and filename prefix for the files in the Cisco IOS configuration archive.
You first save the current running configuration in the configuration archive as follows:
archive config
You then enter configuration changes as shown in the following example:
configure terminal
!
user netops2 password rain
user netops3 password snow
exit
After having made changes to the running configuration file, assume you now want to roll back these changes
and revert to the configuration that existed before the changes were made. The show archive command is
used to verify the version of the configuration to be used as a replacement file. The configure replace command
is then used to revert to the replacement configuration file as shown in the following example:
Device# show archive
There are currently 1 archive configurations saved.
The next archive file will be named flash:myconfiguration-2
Archive #
0
1
2
3
4
5
6
7
8
9
10
Device# configure replace flash:myconfiguration-1
Total number of passes: 1
Rollback Done
Feature History for Configuration Replace and Configuration
Rollback
This table provides release and related information for features explained in this module.
These features are available on all releases subsequent to the one they were introduced in, unless noted
otherwise.
Name
flash:myconfiguration-1 <- Most Recent
System Management Configuration Guide, Cisco IOS XE Fuji 16.8.x (Catalyst 9500 Switches)
Feature History for Configuration Replace and Configuration Rollback
229