Fixture Maintenance; Standard Cleaning - Cooper IB519142EN Installation Instructions Manual

Fixture Maintenance

1. To service fixture remove from T-grid to access LED
Boards. Remove door cover from fixture, 12 screws 3
per side (Figure 5)
Figure 5.
To access LED Drivers
2. Remove End caps, 8 screws 2 per side. Remove LED
tray, 4 screws 2 per side. Silde LED tray towards open
end to access Driver. (Figure 6)
End Caps
Led Tray screws
Figure 6.
Installation Instructions – APN Instruction Sheet

Standard Cleaning

1.
2.
3.
Led Tray screws
Remove End Caps
to access LEDs Tray
and Driver
Cooper Lighting Solutions
Thoroughly pre-rinse with warm water to loosen and
wash away surface material, grit and grime.
Using a soft microfiber cloth or moist non-adrasive
sponge, gently wash with a mild diluted soap or
detergent.
Rinse thoroughly with lukewarm clean water. To prevent
water spots, thoroughly dry the glazing with a dry soft
cloth.
IB519142EN Installation instructions
3