Table of Contents
Advertisement
Additional options are often available on the next page of a display. More... in the
lower, right corner of a display indicates that additional pages of that display are
available. To see more options, page down to the next display.
Note: The keyboard sequence to page down may differ among workstation display
types. Use the documentation that came with your display if you need to know
how to page down.
2) Select Entire system and press Enter.
Read this display which explains what happens during the save process.
3) Press Enter.
4) The Specify Command Defaults display appears.
5) Change Vary off network servers . . . . . *ALL
6) Unmount file systems . . . . . Y is on the first page.
7) Page down to the next display, Specify Command Defaults.
8) Change Print system information. . . Y
9) Press Enter.
Note: Some of the following steps may take several minutes to complete. The X on the
bottom, left side of the display means that the command is processing.
During the save operation, numerous displays for saving various objects will be
shown to you. The default values are filled in for you. You will only need to press
Enter to continue the save operation.
If, during the save operation, your workstation screen goes blank, simply push
any key other than Enter or the spacebar to make the display visible again.
10) The End Subsystem (ENDSBS) display appears. Press Enter.
11) The Save System (SAVSYS) display appears. Press Enter twice.
12) The Save Library (SAVLIB) display appears. Press Enter.
13) The Save Document Library Object (SAVDLO) display appears. Press Enter.
14) The Save Object (SAVOBJ) display appears. Press Enter.
15) The Start Subsystem (STRSBS) display appears. Press Enter.
16) The Save display appears with the following message:
Save or restore operation completed successfully.
Attention: Print the job log. The job log contains information about the save operation.
Use the job log to verify that all objects are saved. Type one of the following:
DSPJOBLOG * *PRINT
Or,
SIGNOFF *LIST
17) Remove the media when the save option is complete. Store the media in a secure,
accessible location. One copy should be kept onsite, and another copy should be kept
offsite in case some unexpected event occurs at your site.
18) Press F3 (Exit) to return to the Main Menu.
19) Continue with "Changing the modem country identifier" on page 8.
Back Up Your System
Getting your twinaxial system running
7
Advertisement
Table of Contents
