Table of Contents
Advertisement
d. Select Device operations and press Enter.
e. Select Tape and press Enter.
f. Select Initialize a tape and press Enter.
g. Type the following information:
Type choices, press Enter.
Device . . . . . . . . . . . . .
New volume identifier . . . . .
New owner identifier . . . . . .
Volume identifier . . . . . . .
Check for active files . . . . .
Tape density . . . . . . . . . .
Code . . . . . . . . . . . . . .
End of tape option . . . . . . .
Clear . . . . . . . . . . . . .
F3=Exit F4=Prompt F5=Refresh F12=Cancel F13=How to use this display
F24=More keys
Leave all the other values as they appear on the display.
h. Press Enter.
i. The tape unit rewinds the tape, which takes a few minutes. The light on the tape unit turns
off.
j. The Tape display appears with the following message:
Volume SAVT01 prepared for operation with owner ID *BLANK.
k. Save the entire system on tape by performing the following:
1) Type Go Save on any command line and press Enter.
Additional options are often available on the next page of a display. More... in the lower,
right corner of a display indicates that additional pages of that display are available. To
see more options, page down to the next display.
Note: The keyboard sequence to page down may differ among workstation display
types. Use the documentation that came with your display if you need to know
how to page down.
2) Select Entire system and press Enter.
Read this display which explains what happens during the save process.
3) Press Enter.
4) The Specify Command Defaults display appears.
5) Change Vary off network servers . . . . . *ALL
6) Unmount file systems . . . . . Y is on the first page.
7) Page down to the next display, Specify Command Defaults.
8) Change Print system information. . . Y
9) Press Enter.
Note: Some of the following steps may take several minutes to complete. The X on the
bottom, left side of the display means that the command is processing.
Initialize Tape (INZTAP)
tap01_____ Name
savt01
Character value, *NONE...
*BLANK
*MOUNTED
Character value, *MOUNTED
*no
*YES, *NO, *FIRST
*DEVTYPE
*DEVTYPE, *CTGTYPE, *QIC120...
*EBCDIC
*EBCDIC, *ASCII
*REWIND
*REWIND, *UNLOAD
*NO
*NO, *YES
Back Up Your System
Bottom
Getting your twinaxial system running
5
Advertisement
Table of Contents
