Table of Contents
Advertisement
Back Up Your System
During the save operation, numerous displays for saving various objects will be
shown to you. The default values are filled in for you. You will only need to press
Enter to continue the save operation.
If, during the save operation, your workstation screen goes blank, simply push any
key other than Enter or the spacebar to make the display visible again.
10) The End Subsystem (ENDSBS) display appears. Press Enter.
11) The Save System (SAVSYS) display appears. Press Enter twice.
12) The Save Library (SAVLIB) display appears. Press Enter.
13) The Save Document Library Object (SAVDLO) display appears. Press Enter.
14) The Save Object (SAVOBJ) display appears. Press Enter.
15) The Save Object (SAV) display appears. Press Enter.
16) The CHKTAP display appears. Press Enter.
17) The Start Subsystem (STRSBS) display appears. Press Enter.
18) The Save display appears with the following message:
Save or restore operation completed successfully.
Attention: Print the job log. The job log contains information about the save operation.
Use the job log to verify that all objects are saved. Type one of the following:
DSPJOBLOG * *PRINT
Or,
SIGNOFF *LIST
19) Remove the media when the save option is complete. Store the media in a secure,
accessible location. One copy should be kept onsite, and another copy should be kept
offsite in case some unexpected event occurs at your site.
20) Press F3 (Exit) to return to the Main Menu.
21) Continue with "Changing the modem country identifier" on page 8.
__ 4. Do the following to initialize the DVD-RAM optical media:
a. Label the media SAVO01.
b. Insert the DVD–RAM into the optical media unit.
c. Select General system tasks on the Main Menu. Press Enter.
d. Select Device operations and press Enter.
e. Select Optical and press Enter.
f. Select Work with optical volumes and press Enter.
g. Select the option to Initialize.
h. Change New volume identifier . . . . . . SAVO01
i. Change Check for an active volume . . . . . . *no
Leave all the other values as they appear on the display.
j. Press Enter.
k. The Work with Optical Volumes display appears with the following message:
Command INZOPT completed normally.
l. Press PF3 to get back to the Main Menu.
m. Save the entire system on DVD–RAM optical media by performing the following:
1) Type go save on any command line and press Enter.
6
iSeries Setting Up Your Twinaxial System V5R3
Advertisement
Table of Contents
