Move Unit Manually; Maintenance; Service Position - Gravely Pro-Stance 48 Operator's Manual

MOVE UNIT MANUALLY

Bypass the transaxles to move the unit with
the engine off.
1. Place steering levers in neutral position
and engage parking brake.
2. Stop engine, remove key and wait for
moving parts to stop and for hot parts to
cool.
3. Pull both transaxle bypass levers out into
bypass position. See Figure 14.
Figure 14
4. Release parking brake and push unit to
desired location.
5. Engage parking brake.
6. Push bypass levers into operating
position. See Figure 15.
Figure 15

MAINTENANCE

WARNING: AVOID INJURY.
Read and understand entire
Safety section before
proceeding.
Proper maintenance can prolong the life of
unit. The Maintenance Schedule on page 20
shows the recommended service schedule.
Your Gravely dealer can provide service and
adjustments to keep your unit operating at
peak efficiency. Contact an authorized engine
manufacturer's service center for engine
service.
More frequent service may be required due to
working conditions (heavy loads, high
ambient temperatures, dusty conditions, or
airborne debris).
See the maintenance instructions in the
Engine Manual for additional information.

SERVICE POSITION

1. Park unit on a flat, level surface.
2. Stop engine, remove key and wait for
moving parts to stop and for hot parts to
cool.
3. Chock wheels. Strap and clamp unit onto
lift, if used.
4. Place steering levers in neutral position
and engage parking brake.
5. Open belt access panel as needed. See
Figure 16.
6. Open rear access panel as needed. See
Figure 17.
EN - 19
Figure 16