Set Operator Platform; Operation; Emergency Stopping; Start The Engine - Gravely Pro-Stance 48 Operator's Manual

SET OPERATOR PLATFORM

CAUTION: Platform will drop
when latch is released. Stand
clear when releasing platform.
See Figure 13.
To rotate platform up:
1. Rotate platform up until platform latch
fully engages lock bolt on platform.
To rotate platform down:
2. Release platform latch.
3. Rotate platform down into standing
position.
1. Platform Latch
2. Lock Bolt
Figure 13
IMPORTANT: All references to left, right, front
or rear are given from the perspective of
operator in operator's position, facing the
direction of forward travel.

EMERGENCY STOPPING

1. Return steering levers to neutral position.
2. Engage parking brake.
3. Push PTO switch down to off position.
1
4. Turn key to off position and remove from
ignition.

START THE ENGINE

2
1. Move steering levers to neutral position.
2. Engage parking brake.
3. Push PTO switch down to off position.
Models 994132, 133, 134, 137 only:
4. If engine is cold, move choke control
lever to the on position. DO NOT use
choke on a warm engine.
5. Move throttle control lever to 3/4 fast
position.
6. Insert ignition key and turn to the start
position. Release key when engine starts.
NOTICE: Do not operate the starter for more
than 10 seconds per starting attempt. If the
engine does not start, allow a 60-second cool
down period between starting attempts.
7. Gradually move choke control lever to the
off position after engine starts.
Models 994141, 994142 only:
8. Move throttle control halfway between the
slow and fast positions.
9. Insert the ignition key in the switch and
turn the key switch to the on position for
one minute. This allows the fuel pump to
cycle and prime the system.
10. Turn key to off position.
EN - 17

OPERATION

WARNING: AVOID INJURY.
Read and understand the
Safety section before
proceeding.
WARNING: AVOID INJURY.
Operating on slopes may lead
to loss of steering control. Be
prepared to react.