Stop The Engine; Move Unit Manually - Gravely 915172 Operator's Manual

For Best Mowing Results
• Cut grass when it is dry.
• Keep mower blades sharp.
• Keep mower deck properly leveled.
• Do not set height of cut too low. For very
tall grass, mow twice.
• Do not travel too fast.
• Mow with the engine set at full throttle.
• When mulching, only remove 1/3 of grass
length per cutting. Do not cut more than
2.5 cm (1") at any one time.
• Discharge clippings into areas already cut.
• Vary cutting pattern with each mowing.
• Do not allow grass or debris to collect
inside of mower deck. Clean after each
use.

STOP THE ENGINE

WARNING: AVOID INJURY.
Wait for all moving parts to
stop before leaving operator's
position.
1. Move steering levers to neutral position.
2. Engage parking brake.
3. Push PTO knob down to off position.
4. Set throttle to slow speed.
5. Turn ignition key to off position and
remove key from ignition.

MOVE UNIT MANUALLY

See Figure 10 and See Figure 11.
IMPORTANT: There is one transaxle bypass
lever on each side of unit. Ensure that both
levers are fully in front or rear position.
• To disengage the transaxles and move unit
with the engine off, place both bypass
levers in the rear position.
• To engage transaxles and operate unit
normally, place both bypass levers in the
front position.
Models 915200, 915202, 915204, 915206,
915216, 915218, 915238, 915240, 915242
Models 915172, 915174, 915176,
Rear Position
Front Position
EN - 15
Rear Position
Front Position
Figure 10
915230, 915236
Figure 11