Connecting Peripheral Devices After Installing The Server In The Rack Cabinet; Labeling A Server With Product Id And Manufactures Number - Fujitsu PRIMERGY PG-R1CK20 User Manual

3.7
Connecting peripheral devices after install-
ing the server in the rack cabinet
Connect peripheral devices after installing the server in the rack cabinet.
When connecting cables of peripheral devices, make sure to maintain the space for drawing out the
server of the rack. When the server is drawn out of the rack, the power cable could be unexpectedly
pulled out. To prevent this problem, first plug in the power cable, then bind it at approximately 10 cm
from the connector to the ventilation holes on the rear of the server using the supplied release tie (as
shown below).
When plugging off the cable, make sure to unplug the connector at the server end.
3.8
Labeling a server with product ID and
manufactures number
Attach the "Product ID and manufactures number label" that you filled in according to "2.2 Pre-work
preparations" ( pg.34).
Product ID and manufactures number may be required when you contact an office
listed in the "Contact Information" of "Start Guide" in case of server failure. Make sure
to attach the label in place.
Product ID
MODEL PG XXXXXX
ST XXX A XXXXX
Manufactures
number
3 Converting and installing the server
E
49