Troubleshooting; Introduction - Troubleshooting; Fault Messages - Husqvarna Automower105 Operator's Manual

Table of Contents

Advertisement

6.1 Introduction - troubleshooting

In this chapter you can find information and help about faults and symptoms of the product. You can find more
information and FAQ (Frequently Asked Questions) on www.husqvarna.com.

6.2 Fault messages

The fault messages in the table below are shown in the display of the product. Speak to your Husqvarna
representative if the same message shows frequently.
Message
Cause
Wheel motor
Grass or other object has wrapped around
blocked, left/right
the drive wheel.
Cutting system
Grass or other object has wrapped around
blocked
the blade disc.
The blade disc lies in a pool of water.
The grass is too high.
Trapped
The product is stuck in a small area behind a
number of obstacles.
Outside working area The boundary wire connections to the charg-
ing station are crossed.
The boundary wire is too close to the edge of
the work area.
The work area slopes too much by the boun-
dary loop.
The boundary wire is laid in the wrong direc-
tion around an island.
Disturbances from metal objects (fences, re-
inforcement steel) or buried cables close by.
The product finds it hard to distinguish the
signal from another product installation close
by.
1285 - 006 - 17.03.2021

6 Troubleshooting

Action
Check the drive wheel and remove the grass
or other object.
Check the blade disc and remove the grass
or other object.
Move the product and prevent the collection
of water in the work area.
Cut the grass before you install the product.
Make sure that the grass is maximum 4 cm /
1.6 in.
Check if there are any obstacles which make
it hard for the product to move on from this
location. Remove the obstacles or create an
island around the obstacles. Refer to
make an island on page 16 .
Check that the boundary wire is connected
correctly.
Check that the boundary wire has been laid
according to the instructions. Refer to
stall the boundary wire on page 19 .
Try moving the boundary wire.
Put the product in the charging station and
generate a new loop signal.
®
To
To in-
Troubleshooting - 29

Advertisement

Table of Contents
loading

Table of Contents