Table of Contents
Advertisement
7 Transportation, storage and disposal
7.1 Transportation
The supplied Li-ion batteries obey the Dangerous Goods
Legislation requirements.
•
Obey all applicable national regulations.
•
Obey the special requirement on package and
labels for commercial transportations, including by
third parties and forwarding agents.
7.2 Storage
•
Fully charge the product. Refer to
battery on page 26 .
•
Switch off the product. Refer to
product on page 26 .
•
Clean the product. Refer to
page 27 .
•
Keep the product in a dry, frost free space.
•
Keep the product with all wheels on level ground
during storage, or use an original wall hanger if
available.
•
If you keep the charging station indoors,
disconnect and remove the power supply and all
the connectors from the charging station. Put the
end of each connector wire in a container with
grease.
Note:
If you keep the charging station outdoors, do
not disconnect the power supply and the connectors.
7.3 Disposal
•
Obey the local recycling requirements and
applicable regulations.
•
For questions about how to remove the battery,
refer to
To remove the battery on page 40 .
7.3.1 To remove the battery
Follow these steps for removal of the battery from the
product.
1.
Set the Main switch in position
2.
Set the cutting height to its lowest position.
3.
Turn the product upside down.
4.
Clean around the battery cover.
5.
Remove the 4 screws to the battery cover (Torx
20) and remove the battery cover.
40 - Transportation, storage and disposal
6.
7.
To charge the
To switch off the
Clean the product on
0 .
Remove the screw of the battery retaining bracket
and remove the bracket.
Pull out the battery by pulling on the strap.
1285 - 006 - 17.03.2021
Advertisement
Table of Contents
