Table of Contents
Advertisement
7.
Put the boundary wire or the guide wire into
position with stakes.
8.
Connect the charging station to the power outlet.
3.9 After the installation of the product
3.9.1 To do a visual check of the charging
station
1.
Make sure that the indicator LED lamp on the
charging station has a green light.
2.
If the indicator LED lamp does not have a green
light, do a check of the installation. Refer to
Indicator lamp in the charging station on page 35
To install the charging station on page 18 .
and
3.9.2 To do the basic settings
Before the product starts to operate for the first time, you
must do the basic settings.
1.
Put the product in the charging station.
2.
Switch on the product.
3.
Push the arrow buttons and the OK button. Select
language, country, date, time and set a PIN code.
Note:
For some models, a factory PIN code is
necessary before you select a personal PIN code.
It is not possible to use 0000 as PIN code.
4.
Push the Start button and close the hatch to initiate
a calibration process of the product.
Note:
If the battery is too low, the product needs
to charge the batteries fully before the calibration
Calibration on page 21 .
starts. Refer to
1285 - 006 - 17.03.2021
Note:
Make a note of the PIN code. Refer to
Introduction on page 3 .
3.9.3 Calibration
The calibration process is automatic. After the basic
settings are done, the product moves away from the
charging station and stops, while it calibrates some of
the product settings. When the calibration is complete,
the product starts to mow.
3.10 To do the product settings
Use the control panel to set all settings for the product.
The control panel has a display and a keypad, you can
access all functions through the menus. The functions
have factory settings that is applicable for almost all
work areas, but the settings can be adapted to the
conditions for each work area.
3.10.1 Menu structure
The main menu contains:
Timer
•
Installation
•
Security
•
•
Settings
Menu structure overview on page 7 .
Refer to
3.10.2 To get access to the menu
1.
Push the STOP button.
2.
Enter the PIN code on the keypad.
3.
Push the multi-choice button.
3.10.3 To do the timer settings
Note:
Timer if the work area is less than 600
Set the
2
m
/ 0.15 acre to prevent wear on the lawn and wear on
the product.
3.10.3.1 To set the timer
To get access to the menu on
1.
Do steps 1–3 in
page 21 .
2.
Use the multi-choice buttons to move through the
menu structure to select
3.
Use the multi-choice buttons to select
1 or Work hours 2 .
4.
Enter the time with the number buttons.
5.
Push
OK .
6.
Use the multi-choice buttons to select
Timer .
Work hours
Work days .
Installation - 21
Advertisement
Table of Contents
