Indicator Lamp In The Charging Station - Husqvarna Automower105 Operator's Manual

6.4 Indicator lamp in the charging station

The indicator lamp in the charging station must show a solid or flashing green light for a correct installation. If not,
follow the instructions in the troubleshooting guide below.
You can also find information on www.husqvarna.com. Speak to your Husqvarna
information.
Light
Green solid light
Green flashing light
Blue flashing light
Yellow flashing light
Red flashing light
Red solid light
1285 - 006 - 17.03.2021
Cause
Good signals.
The signals are good and ECO mode is
activated.
The boundary loop is not connected to
the charging station.
Break in the boundary loop.
The guide wire is not connected to the
charging station.
Break in the guide wire.
Interruption in the charging station's an-
tenna.
Fault in the circuit board or incorrect
power supply in the charging station.
The fault should be rectified by an au-
thorized service technician.
®
customer service for more
Action
No action required.
No action required. For more information on
ECO mode , Refer to ECO mode on page 24 .
Check that the boundary wire connector is fit-
ted properly to the charging station. Refer to
To install the boundary wire on page 19 .
Find out where the break is. Replace the
damaged section of the boundary wire with a
new loop wire and splice using an original
Find breaks in the loop wire
coupler. Refer to
on page 37 .
Check that the guide wire connector is prop-
erly connected to the charging station. Refer
to To install the guide wire on page 19 .
Find out where the break is. Replace the
damaged section of the guide wire with a new
loop wire and splice using an original coupler.
Contact your local Husqvarna
tive.
Contact your local Husqvarna
tive.
Troubleshooting - 35
®
representa-
®
representa-