Buick 2006 Rainier Maintenance Manual page 264

Vehicles with a DIC
®
StabiliTrak
Indicator Light
Solid
Solid
Notice: If the StabiliTrak
heavy braking and/or because the traction control
system has been continuously active, do not
allow the wheel(s) of one axle to spin excessively.
If you do, you may be causing damage to the
transfer case. This could lead to costly repairs
not covered by
your warranty.
Notice: If you allow the wheel(s) of one axle to spin
excessively while the StabiliTrak
warning lights and the SERVICE STABILITRAK
message are displayed, you could damage the
transfer case. The repairs would not be covered
by your warranty. Reduce engine power and do not
spin the wheel(s) excessively while these lights
and this message are displayed.
4-12
DIC Message
Indicator Light
Service
®
StabiliTrak
®
StabiliTrak
Not Ready
®
light comes on due to
®
, ABS and brake
Vehicles without a DIC
®
StabiliTrak StabiliTrak
Service Light
Solid
Solid
®
StabiliTrak may activate on dry or rough roads or under
conditions such as heavy acceleration while turning or
abrupt upshifts/downshifts of the transmission. When this
happens, you may notice a reduction in acceleration, or
may hear a noise or vibration. This is normal.
If your vehicle is in cruise control when the system
activates, the StabiliTrak
cruise control will automatically disengage. When
road conditions allow, you may re-engage the cruise
control. See Cruise Control on page 3-11.
®
StabiliTrak will turn off automatically if a problem is
detected in the system. The StabiliTrak
on and SERVICE STABILITRAK will be displayed on
the DIC. For vehicles without a DIC, the StabiliTrak
light and the StabiliTrak
Event
®
StabiliTrak
Solid is disabled due to
a system fault.
StabiliTrak
Off disabled due to a
failure to initialize.
®
light will blink, and the
®
light will come
®
service light will both come on.
®
system
®
system is
®