Dismantling The Main Switch - Husqvarna 536LiL Workshop Manual

Dismantling the main switch

For products with S/N: 2015080001- (536LiL,
536LiLX), 20151000001- (536LiR, 536LiRX).
1
Dismantle the operating handle.
Refer to "Basic dismantle/assembly".
2
Dismantle the throttle trigger lock and throttle trigger.
Refer to "Dismantling the throttle trigger lock and
throttle trigger"-
3
Lift out the main switch and disconnect the yellow
wire (A).
See figure 10b.
4
Take loose the contact (C) using a small screw-
driver to carefully free the catches (D) on each end
of the contact and main switch from each other.
NB! Do not pull the wires. Take special care
to avoid damaging the contact (D).
See figure 11b.
Cleaning and inspection
Clean and check the main switch. The main switch
must always be replaced with a new one if cracked
or showing signs of other defects.
Always use original spare parts.
See figure 12
9.6 Assembling the main switch
For products with S/N: -2015080000 (536LiL),
-2015100000 (536LiR).
1
Connect the contact (C) to the main switch. NB!
Make sure to apply grease to the contact
surfaces and also the connector.
See Figure 13a.
2
Connect the red wire (B) and the yellow wire (A)
and place the main switch in the battery housing.
See Figure 14a.
3
Assemble the throttle trigger lock and throttle trigger.
Refer to "Assembling the throttle trigger lock and
throttle trigger".
4
Assemble the operating handle.
Refer to "Basic dismantle/assembly".
Fig 10b
D
D
Fig 11b
Fig 12
C
Fig 13a
Fig 14a
Repair Instructions
A
C
B
A
– 43
English