Battery; Operating Handle Lil/Lilx; Operating Handle Lir/Lirx - Husqvarna 536LiL Workshop Manual

The steps described below are the basic steps that must be carried out before any other service or repair
work or final assembly is possible.
Fasten the shaft in a vice so you have both hands free and to facilitate carrying out the steps described below.

7.1 Battery

Press in the catches and remove the battery.
See figure 1.
Replace the battery once assembly has been
completed.
WARNING!
The battery must always be removed
for service/repair work and may only
be replaced once the trimmer has
been completely assembled again!
NOTE!
Note how wires, components, etc., are
positioned before dismantling.
Make sure to position them correctly to avoid
pinching when the trimmer is reassembled.
7.2 Operating handle LiL / LiLX / LiC
Loosen the screws (6x) and lift off the handle.
Assemble in the reverse order.
Tightening torque 2 ~ 3 Nm.
See figure 2
7.3 Operating handle LiR / LiRX
Loosen the screws (A 3x) and (B 1x) and lift off the
handle from the handle tube.
Assemble in the reverse order.
Tightening torque (A 3x) 2 ~ 3 Nm
Tightening torque (B 1x) 3 ~ 4 Nm
See figure 3
7 Basic dismantle/assembly
1
2
Fig 1
Fig 2
Fig 3
Basic dismantle/assembly
1
A
B
– 29
English