Assembling The Throttle Trigger Lock And Throttle Trigger - Husqvarna 536LiL Workshop Manual

8.6 Dismantling the throttle trigger lock
and throttle trigger
1
Dismantle the operating handle.
Refer to "Basic dismantle/assembly".
2
Lift off the throttle trigger lock and the throttle
trigger from their attachments in the handle.
LiL/LiLX/LiC - See figure 13.
LiR/LiRX - See figure 14.
Cleaning and inspection
• Clean and check all parts thoroughly. Parts must
be replaced if cracked or showing signs of other
defects. Always use original spare parts.
• Check that the spring blade is intact and retains
all its tension.
See Figure 15
8.7 Assembling the throttle trigger lock
and throttle trigger
1
Assemble the throttle and throttle lockout on their
respective attachments on the handle. Make sure
that the spring blade comes under the keypad.
LiL / LiLX / LiC - See figure 16.
LiR / LiRX - See figure 17.
2
Assemble the operating handle.
Refer to "Basic dismantle/assembly".
Fig 13
Fig 14
LiL/LiLX / LiC
Fig 15
Fig 16
Fig 17
Safety equipment
LiR/LiRX
– 37
English