Dismantling.the.main.switch.and.main.cabling; Assembling.the.main.switch.and.main.cabling - Husqvarna LiHD50 Workshop Manual

10.12 Dismantling the main switch and
main cabling
The keypad should be disconnected to facili-
tate dismantling.
See Chapter 10.10.
1
Loosen contact (A) from pin B+ on the main switch.
See figure 36.
2
Take loose the connector (B) using a small screw-
driver to carefully free the heels (C) on each end of
the connector and main switch from each other.
NOTE!
Do not pull the wires. Take special care to
avoid damaging the contact (B).
See figure 37.
Cleaning and inspection
Clean and inspect the main switch and cables.
They must always be replaced with new ones if
cracked or showing signs of other defects.
Always use original spare parts.
WARNING!
The "button" on the main switch
may only be tested when it is as-
sembled in the handle!
See figure 38.
10.13 Assembling the main switch and
main cabling
1
Connect the contact (B) to the main switch.
See figure 39.
2
Connect contact (A) and the yellow wire (A) and
place the main switch in the chassis.
See figure 36.
Repair instructions LiHD60X / LiHD70X
A
Fig.36
C
C
Fig.37
Fig.38
B
Fig.39
B
English 51
–