KTM 450 SMR 2021 Owner's Manual page 56

11 SERVICE WORK ON THE CHASSIS
54
–
Position the foot brake cylinder.
Push rod
Info
Ensure that the dust boot is correctly seated.
–
Mount and tighten screws
Guideline
Remaining screws,
K01098-01
chassis
–
Position the angle lever and linkage lever.
–
Mount and tighten fitting
Guideline
Nut, linkage lever on
angle lever
Info
Pay attention to flat area
F00425-10
–
Mount and tighten screw
Guideline
Screw, bottom
shock absorber
Info
Raise the swingarm slightly to be able to mount the
screw more easily.
–
Position the left frame protector.
–
Insert the right frame protector from below and push it to the
rear.
–
Mount and tighten screws
Guideline
Screw, frame protec-
tor
–
Mount and tighten screw
F01527-11
Guideline
Screw, frame protec-
tor
–
Mount the new cable ties.
Finishing work
–
Check the free travel of the foot brake lever. (
–
Remove the motorcycle from the lift stand. (
4
engages in the foot brake cylinder.
5
.
M6 10 Nm (7.4 lbf ft)
6
.
M14x1.5 60 Nm (44.3 lbf ft)
B
.
7
.
M10 60 Nm (44.3 lbf ft)
8
with the washers.
M5 3 Nm (2.2 lbf ft)
9
.
M5 3 Nm (2.2 lbf ft)
Loctite ® 2701™
p. 78)
p. 42)