Installing The Network-Port Bracket - Dell Vostro 14 5415 Service Manual

Steps
1. Remove the two screws (M2.5x5) that secure the left-display hinge to the I/O board.
2. Pry open the left-display hinge at an angle of 90 degrees.
3. Remove the two screws (M2x5) that secure the network-port bracket to the I/O board.
4. Lift the network-port bracket off the I/O board.

Installing the network-port bracket

Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the network-port bracket and provides a visual representation of the installation
procedure.
36 Removing and installing components