Table of Contents
Advertisement
7. Connect the keyboard-backlight cable to the system board and close the latch.
8. Place the I/O-board and antenna cables back into place and adhere the tapes that secure them to the palm-rest and
keyboard assembly.
Next steps
1. Install the
3-cell battery
2. Install the
base
cover.
3. Follow the procedure in
Touchpad
Removing the touchpad
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the
3-cell battery
About this task
The following image(s) indicate the location of the touchpad and provides a visual representation of the removal procedure.
Steps
1. Open the latch and disconnect the touchpad cable from the touchpad.
2. Remove the three screws (M1.6x2) that secure the touchpad bracket to the palm-rest and keyboard assembly.
3. Lift the touchpad bracket off the palm-rest and keyboard assembly.
4. Remove the two screws (M2x1.8) that secure the touchpad to the palm-rest and keyboard assembly.
5. Peel the tapes that secure the touchpad to the palm-rest and keyboard assembly.
6. Lift the touchpad off the palm-rest and keyboard assembly.
42
Removing and installing components
or the
4-cell
battery, whichever applicable.
After working inside your
Before working inside your
or the
4-cell
battery, whichever applicable.
computer.
computer.
Advertisement
Table of Contents
