Table of Contents
Advertisement
[Hexadecimal]
To change the number system to hexadecimal decimal or binary, press the
Note :
• When the data is displayed in hexadecimal, the letter "H" is displayed on the display of the
FP Programmer.
[Binary]
To change the number system to binary from decimal or hexadecimal, press the
press the
key.
SHIFT
SC
Note :
• On the AFP1112 and the AFP1112A FP Programmers, the
as the
key on the AFP1114.
SHIFT
SC
4) If you want to monitor the data in the previous address or the next address, use the
5) If the
key pressed twice in succession, you can select another word special internal relay or special data
(HELP)
CLR
register using the same procedure as described in step 3).
6) If the
key is pressed, the FP Programmer will exit from the OP 8 mode.
ACLR
6-2. How to Read Special Internal Relays(R) & Special Data Registers(DT)
key.
(BIN)
K/H
key and then
(BIN)
K/H
key is used in the same
SC
or the
READ
SRC
key
69
Advertisement
Table of Contents
