Table of Contents
Advertisement
3-13 SET SUPERVISOR/USER PASSWORDS
Set Supervisor Password
Set User Password
↑↓→← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values
You can set either supervisor or user password, or both of them. The differences are:
Supervisor password:
User password:
ENTER PASSWORD:
Type the password, up to eight characters in length, and press <Enter>. The password typed
now will clear any previously entered password from CMOS memory. You will be asked to
confirm the password. Type the password again and press <Enter>. You may also press <Esc>
to abort the selection and not enter a password.
To disable a password, just press <Enter> when you are prompted to enter the password. A
message will confirm that the password will be disabled. Once the password is disabled, the
system will boot and you can enter Setup freely.
PASSWORD DISABLED.
When a password has been enabled, you will be prompted to enter it every time you try to enter
Setup. This prevents an unauthorized person from changing any part of your system
configuration.
Additionally, when a password is enabled, you can also require the BIOS to request a password
every time your system is rebooted. This would prevent unauthorized use of your computer.
You determine when the password is required within the BIOS Features Setup Menu and its
Security option. If the Security option is set to "System", the password will be required both at
boot and at entry to Setup. If set to "Setup", prompting only occurs when trying to enter Setup.
Phoenix – AwardBIOS CMOS Setup Utility
Password Settings
Press Enter
Press Enter
F6:Optimized Defaults
Can enter and change the options of the setup menus.
Can only enter but do not have the right to change the options of the
setup menus. When you select this function, the following message
will appear at the center of the screen to assist you in creating a
password.
Menu Level >
F7:Standard Defaults
42
Item Help
Advertisement
Table of Contents
