Ricoh IM C530 Series User Manual page 225

Message
"Memory storage device
not detected. Insert the
device."
"Programmed. Cannot
program the
destination(s) that is not
programmed in the
address book."
"Programmed. Cannot
program the folder
destination(s) with
protection code(s)."
Cause
An SD card or USB flash
memory device is not
recognized properly.
A folder specified by
Manual Entry is
included among the
programmed
destinations.
A destination specified
with a protection code is
included among the
programmed
destinations.
When a Message Appears While Using the Scanner Function
Solution and reference
• Use an SD card with a maximum
capacity of 32 GB or a USB flash
memory that supports USB 2.0.
• An SD card or USB flash memory may
not be recognized in some situations such
as if the media is inserted before the
application starts. Insert the SD card or
USB flash memory after the application
has started.
• Do not use an SD card or USB flash
memory that is not secured or protected
by a password.
• Use media that is formatted for FAT16 or
FAT32.
• Try another SD card or USB flash
memory.
• Turn off the power of the machine, wait
for 10 seconds or more after confirming
that the main power indicator is turned
off, and then turn on the power.
Register the destination in the address book of
the machine, and then register it to a program.
• You cannot program a destination
specified with a protection code. Specify
this destination individually.
• To program this destination, cancel the
protection code and then register the
destination to a program.
See "Using the Protection Function to
Prevent the Misuse of Addresses", User
Guide (Full Version).
223