Kodak S2000 Series User Manual page 71

Appendix A Regulatory Information
Notice to users in Thailand: This wireless communication equipment has the electromagnetic field strength in
compliance with the Safety Standard for the Use of Wireless Communication Devices on Human Health
announced by the National Telecommunications Commission.
Notice to users in the US: FCC: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed or used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
1) reorient or relocate the receiving antenna;
2) increase the separation between the equipment and the receiver;
3) connect the equipment to an outlet on a circuit different from that to which the receiver is connected;
4) consult the dealer or an experienced radio/TV technician for additional suggestions.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment. Where shielded interface cables have been provided with the product or
specified additional components or accessories elsewhere defined to be used with the installation of the product,
they must be used in order to ensure compliance with FCC regulation.
FCC ID: PPQ-WN4615L
Networking Performance Statement, notice to users: It should be understood that wireless networks and,
therefore, system performance, are impacted negatively by a number of factors including: interference from other
RF sources; physical obstructions; distance between devices; and relative location. Competing network traffic will
additionally degrade performance for both wired and wireless interfaces.
A-61931 April 2021 63