Emc And Wireless Regulatory Statements For S2000W Series Scanners - Kodak S2000 Series User Manual

Appendix A Regulatory Information
Notice to users in
Japan: This is a Class B product based on the standard of the Voluntary Control Council for interference
by information Technology Equipment (VCCI). If this is used near a radio or television receiver in a domestic environment, it may
cause radio interference. Install and use the equipment according to the instruction manual.

EMC and Wireless Regulatory Statements for S2000w Series Scanners:

This device contains a preinstalled 2.4 GHz Wireless LAN module (Model: WN4615L)
For Indoor Use: This device is intended for indoor use only.
Radio Frequency Exposure
CAUTION: When using this product, it should be installed and operated with a minimum distance of 7.9 in. (20 cm)
for 2.4 GHz operations between the radiator and your body. This transmitter must not be collocated or operated in
conjunction with any other antenna or transmitter. The radiated output power of this device is far below radio
frequency exposure limits during normal operation.
Notice to users in Argentina: Acceso Inalambrico de Red
CNC C-20571, CNC C-20572
Notice to users in Brazil: "Este equipamento opera em caráter secundário, isto é, não tem direito a proteção
contra interferência prejudicial, mesmo de estações do mesmo tipo, e não pode causar interferência a sistemas
operando em caráter primário."(ANATEL 282/2001)
Anatel: 07890-17-02458
Notice to users in Canada/Note à l'attention des utilisateurs canadiens:
For Indoor Use. This device complies with Industry Canada's licence-exempt RSSs. Operation is subject to the
following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired operation of the
device.
Utiliser à l'intérieur. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
1) l'appareil ne doit pas produire de brouillage;
2) l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement..
The radiated output power of this device is below the Industry Canada (IC) radio frequency exposure limits. This
device has been evaluated for and shown compliant with the IC Radio Frequency (RF) Exposure limits. The device
should be used in such a manner such that the potential for human contact during normal operation is minimized.
This device has been certified for use in Canada. Status of the listing in the Industry Canada's REL (Radio
Equipment List) can be found at the following web address:
http://www.ic.gc.ca/app/sitt/reltel/srch/nwRdSrch.do?lang=eng
60 A-61931 April 2021