Stihl RMA 235 Instruction Manual page 10

English
► Hold upper handlebar (5) against lower han‐
dlebars (1) so the bores align.
► Place cable (10) into cable clip (8).
► On the side with the cable, push screw (6)
through bores (11) in cable clip (8), upper han‐
dlebar (5) and lower handlebar (1) from the
outside inwards.
► On the other side, push screw (6) through
bores (11) in upper handlebar (5) and lower
handlebar (1) from the outside inwards.
► Fit rotary knob (9) onto screws (6) on both
sides and screw in.
Upper handlebar (5) is firmly attached to lower
handlebars (1).
► Place the cable into cable clips (7).
► Press cable clip (7) onto upper handlebar (5)
and allow to engage.
► Press cable clip (12) onto lower handlebar (1)
and allow to engage.
The handlebar must not be dismantled again.
7.2 Folding Up and Folding the
Handlebar
7.2.1 Folding Up the Handlebar
► Switch the lawn mower off, pull out the activa‐
tion key and remove the battery.
► Place the lawn mower on a level surface.
10
7 Assembling the Lawn Mower
► Fold up upper handlebar (2) and hold with one
hand. Make sure that cable (4) is not dam‐
aged.
► Tighten rotary handles (1).
Handlebar (2) is firmly attached to the lawn
mower.
Upper handlebar (2) is firmly attached to lower
handlebar (3).
7.2.2 Folding the Handlebar
The handlebar can be folded for space-saving
transport or storage.
► Switch the lawn mower off, pull out the activa‐
tion key and remove the battery.
► Place the lawn mower on a level surface.
► Unscrew rotary handles (1) until they turn
freely.
0478-131-9866-C