Gemini MyTrack 955MyBASIC User Manual page 3

3.0 - REMOTE CONTROL
The remote control is the main interface with the tracking system; we therefore
recommend you acquaint yourself fully with it.
The remote control has a low charge battery indicator that gives you early
warning to avoid malfunctioning. When the batteries are fully charged, the
LED will show a steady light when pressing the button. If the batteries are too
weak for normal operation, on pressing the button, the LED will start blinking.
Arming/disarming
4.0 - ARMING
To arm the system press once on the remote control button. The LED and the
turn indicators will blink twice to confirm arming.
When the system is armed and, until it is disarmed, the vehicle cannot be started.
The passive arming feature, enabled via SMS (see chapter 9.7 or 18.0),
automatically arms the system 2 minutes after ignition is switched "OFF".
5.0 - DISARMING
To disarm the system press once on the remote control button. The LED and
the turn indicators will blink 3 times to confirm disarming; the vehicle can then
be started.
6.0 - OPTICAL SIGNALS
6.1 - ARMING/DISARMING SIGNALS
LED flashes
Arming
Disarming
Page 2 Page 2
button
LED
indicator
Turn indicator flashes
6.2 - PRE-ALARM SIGNALS
LED flashes
(15 sec.)
Turn indicator
flashes (15 sec.)
NB: see installer manual for the complete list of optical signals.
7.0 - PRE-ALARM AND ALARM
When the tracker is armed, there is a pre-alarm and an alarm stage.
Pre-alarm is signalled by 15 sec. of optical signals (LED and indicator lights)
during which the system can be disarmed via remote control. If the system is
not disarmed, an alarm is triggered and an alert message transmitted to the
"main number" indicating the type of alarm (ignition alarm, tilt alarm, etc.).
The tracker also activates the siren (if connected) and the turn indicators for 30
sec. If no one intervenes within 5 minutes, the system sends a 2nd text
message to the emergency number (par. 9.0 "Commands from/to a mobile
phone"). Ignition remains inhibited.
8.0 - ALARMS
ATTENTION
Whenever an alarm message is sent, the system triggers the siren and
the turn indicators (if connected).
8.1 - IGNITION DETECTION ALARM
This alarm is triggered if ignition key is turned "ON" when the system is armed.
8.2 - TILT ALARM
When the system is armed, attempts to lift or move the vehicle (including hauling or
wheel stealing) will trigger an alarm. To exclude this alarm refer to par. 9.13 or 18.0.
8.3 - POSITION ALARM
The system provides protection against displacement attempts while ignition
is OFF ex. towing ( ). When ignition is switched back "ON", the system
compares the actual position to the position saved when the engine was
powered off. If they differ by more than the factory set tolerance (not
modifiable), the system sends the user an alarm message .
Page 3 Page 3