Gemini MyTrack 955MyBASIC User Manual

Advertisement

Quick Links

INSTALLATION CERTIFICATE
The undersigned qualified installer attests having personally fitted the
tracking system on the vehicle described below following the manufacturer
instructions.
By :
Sold on :
Product type :
.............
...................................
955MyBASIC
Vehicle :
............................................................................................................................
USER MANUAL
Stamp and Signature
..........................................................................................
GEMINI Technologies S.r.l
UK
Via Luigi Galvani 12 - 21020 Bodio Lomnago (VA) - Italia
Tel. +39 0332 943211 - Fax +39 0332 948080
www.gemini-alarm.com
ISO 9001 Certified Company
Made in Italy
REV.00 - 06/17

Advertisement

Table of Contents
loading

Summary of Contents for Gemini MyTrack 955MyBASIC

  • Page 1 Vehicle : ..........................USER MANUAL Stamp and Signature ..................GEMINI Technologies S.r.l Via Luigi Galvani 12 - 21020 Bodio Lomnago (VA) - Italia Tel. +39 0332 943211 - Fax +39 0332 948080 www.gemini-alarm.com ISO 9001 Certified Company Made in Italy...
  • Page 2 Dear Customer, thank you for choosing this self-managed tracking system, 8.2 - Tilt alarm designed and manufactured in Italy by GEMINI TECHNOLOGIES specifically 8.3 - Position alarm for 2-wheeled vehicles. Being highly flexible it can also be used to protect ATVs 8.4 - Battery alarm...
  • Page 3 3.0 - REMOTE CONTROL 6.2 - PRE-ALARM SIGNALS The remote control is the main interface with the tracking system; we therefore LED flashes recommend you acquaint yourself fully with it. (15 sec.) The remote control has a low charge battery indicator that gives you early warning to avoid malfunctioning.
  • Page 4 8.4 - BATTERY ALARM 9.1 - INITIAL CONFIGURATION: Send the following message to initialize the system: The system rovides protection against battery tampering. If one of the power supply cables is cut, the system sends an alarm message to the main number setup#password#basic#main phone number#new (no pre-alarm signal is triggered).
  • Page 5 9.4 - SYSTEM ARMING: 9.9 - VEHICLE SERVICING MODE DEACTIVATION: on#password# seroff#password# When the SMS is sent to the system it will reply: The system will deactivate “valet mode” and reply “Servicing mode disabled”. -System armed; GPS status; latitude; longitude; speed; hour; date. 9.10 - PERIODIC POSITION CONTROL: 9.5 - SYSTEM DISARMING: pos#password#180#...
  • Page 6: Additional Information

    9.13 - TILT SENSOR EXCLUSION 9.17 - BLINKER ACTIVATION: setup#password#nav#main phone number#new blinker#password# password#emergency phone number# When the SMS is sent to the system it will activate the turn indicators for 30 When the SMS is sent to the system it will reply: seconds and then automatically deactivate them.
  • Page 7: Sleep Mode Activation/Deactivation

    11.0 - MESSAGES ATTENTION 11.1 - ERROR MESSAGES The new password must be a 6-digit code and can contain both numbers and letters (i.e.: AA1234 or aa1234); The password is key-sensitive, If a wrong command is sent, the system forwards a “wrong command” therefore by typing characters other than the ones entered ( upper notification.
  • Page 8: Remote Control Battery Replacement

    15.0 - R EMOTE CONTROL BATTERY REPLACEMENT 18.0 - COMMANDS When the remote control batteries are too weak, replace them as follows: REQUEST COMMAND Separate the shell halves taking care not to damage the internal circuit. setup#password#basic#main phone Initial configuration and/or Remove the discharged batteries.

Table of Contents