Gemini MyTrack 955MyBASIC User Manual page 4

8.4 - BATTERY ALARM
The system rovides protection against battery tampering. If one of the power p
supply cables is cut, the system sends an alarm message to the main number
(no pre-alarm signal is triggered). This function is active even when the system
is disarmed, it is only inhibited when the system is in valet mode (par. 9.8 or 13).
8.5 - GENERIC ALARM (GREEN-BROWN wire
ATTENTION
A generic alarm message will only be transmitted if the Green-Brown wire
has been connected and the system configured accordingly.
When a generic message is sent, the system checks the alarm source. If the
alarm source is still active (i.e. seat still open), the input will be inhibited. If no
longer active (i.e. seat closed), the system will automatically rearm
8.6 - WIRELESS SENSORS ALARM
Wireless sensors can be added to protect the area where the vehicle is usually
parked; if one of the sensors detects an alarm condition, an alert message will
be sent to the user mobile phone .
9.0 - COMMANDS FROM AND TO MOBILE PHONE
Before configuring the module, it is important to familiarize yourself with all the
commands available to interact with the system.
Messages for system management (commands) are forwarded to the same
mobile from which they have been transmitted (except tracking and vehicle
immobilizing confirmation).
Alarm messages are received by the preset mobile numbers.
ATTENTION
If a text message is sent with the wrong command, you will receive an
error message (command error).
NB: the time indicated by the system refers to the Greenwich Mean Time (GMT).
Page 4 Page 4
Send the following message to initialize the system:
setup#password#basic#main phone number#new
The default password is the same for all devices "000000", therefore, for security
reasons, we recommend that you change it.
)
The new password
and letters (i.e.: AA1234 or aa1234). The password is key-sensitive,
therefore by typing characters other than the ones entered (
lower case letters are not equivalent), the system will not operate properly.
Commands
.
Main phone number:
alarm condition
UK).
Emergency phone number:
an alarm condition (optional, entering can be omitted).
To confirm reception of an SMS, the system triggers 5 quick flashes of the turn
indicators and the LED and returns a confirmation message to the user
indicating:
setup ok with password=new password.
When the SMS is sent to the system it will reply:
System status (armed or disarmed), GPS status; latitude; longitude;
speed; hour; date.
9.3 - TRACKING (VEHICLE DISPLACEMENT):
When this SMS is sent to the system, 6 SMS will be forwarded (1 approx. every
90 seconds) the 1st one to the sender and the other 5 to the user, indicating:
GPS status; latitude; longitude; speed; hour; date.
1
9.1 - INITIAL CONFIGURATION:
password#emergency phone number#
ATTENTION
must be a 6-digit code and can contain both numbers
can either be sent with capital or small letters.
number to which the SMS will be sent in case of an
always preceded by the international code
second recipient to receive an SMS in case of
9.2 - VEHICLE LOCALIZATION:
loc#password#
trk#password#
upper and
(i.e. +44 for the
Page 5 Page 5