2.9.5 Enabled trigger
The multimeter comes with trigger function, can be triggered by
modes are selectable. Auto trigger is enabled by default after power on.
2.9.6 Auto Trigger
Press
to enable auto trigger to acquire continuous readings automatically. Auto Trigger will be
displayed above the display. Press
2.9.7 Single Trigger
Press
button to enable single trigger once. Single Trigger will be displayed above the display.
2.9.8 Hold Measurement
In Hold measurement, when a serial of stable readout is measured, beeper will beep once and record the
measured value on the display. 8 readings can be remained on the display.
→
Press
Figure2-53.
Menu of Hold measurement
Function
Options Description
menu
Probe Hold
On/Off
Beeper
On/Off
Clear List
2.9.9 Storage Management
UT8805E built-in 1GB Nand Flash memory and external U-disk can be used to save and read the data.
The location, name and format of files are configurable in storage management menu.
→
Press
button to open the menu of storage management as Figure 2-54.
button again to stop trigger.
to enter Hold measurement, Probe Hold will be displayed above the display as
Figure 2-53 Hold measurement
Turn the probe hold function on or off
Turn the beeper on or off
Clear all the history data on list
or
43
UT8805E Benchtop Digital Multimeter
button. Auto or single trigger